How To Drain R134A From Car

If your car’s air conditioner is not working as well as it used to you may need to recharge it. You can do this yourself by adding more Freon but first you need to drain the existing Freon from the system. This can be done by following these steps:

1. Locate the low pressure service port. This is usually located on the larger of the two pipes that connect the air conditioner compressor to the condenser. The low pressure service port will have a cap with either a blue or black top.

2. Use a wrench to remove the cap from the low pressure service port.

3. Connect the Freon can to the low pressure service port. The can will have a hose with a connector that attaches to the port.

4. Open the valve on the Freon can. This will allow the Freon to flow into the car’s air conditioning system.

5. Monitor the pressure gauge on the Freon can. When the pressure reaches the “full” mark close the valve on the can.

6. Replace the cap on the low pressure service port.

Your car’s air conditioner should now be recharged and working properly.

How do you properly drain R134a from a car?

Answer 1: You have to remove the compressor receiver/dryer and hoses from the vehicle.

Once these parts are removed you can drain the R134a from the system.

Is it necessary to completely drain the R134a from the car?

Answer 2: Yes it is necessary to completely drain the R134a in order to avoid damaging the compressor.

How do you remove the compressor?

Answer 3: In order to remove the compressor you must first disconnect the electrical wiring and then unbolt it from the engine.

How do you remove the receiver/dryer?

Answer 4: The receiver/dryer is located between the compressor and the hoses.

To remove it you must first disconnect the hoses and then unbolt it from the vehicle.

How do you remove the hoses?

Answer 5: The hoses are located on the compressor and the receiver/dryer.

To remove them you must first disconnect the fittings and then pull the hoses off.

What are the fittings?

Answer 6: The fittings are the parts that connect the hoses to the compressor and the receiver/dryer.

They can be disconnected by unscrewing them or by using a wrench.

How do you drain the R134a from the system?

Answer 7: You can drain the R134a from the system by opening the valves on the compressor and the receiver/dryer.

Where are the valves located?

Answer 8: The valves are located on the compressor and the receiver/dryer.

What is the purpose of draining the R134a from the car?

Answer 9: Draining the R134a from the car is necessary in order to avoid damaging the compressor.

Are there any other parts that need to be removed in order to drain the R134a from the car?

Answer 10: No the only parts that need to be removed are the compressor receiver/dryer and hoses.

Can the R134a be drained without removing the compressor?

Answer 11: No the R134a must be completely drained in order to avoid damaging the compressor.

What will happen if the R134a is not completely drained from the car?

Answer 12: If the R134a is not completely drained it can damage the compressor.

Is it difficult to remove the compressor?

Answer 13: No it is not difficult to remove the compressor.

You just have to disconnect the electrical wiring and then unbolt it from the engine.

Is it difficult to remove the receiver/dryer?

Answer 14: No it is not difficult to remove the receiver/dryer.

You just have to disconnect the hoses and then unbolt it from the vehicle.

Is it difficult to remove the hoses?

Answer 15: No it is not difficult to remove the hoses.

You just have to disconnect the fittings and then pull the hoses off.

Leave a Comment