How To Jump Start A Car Without A Car

If your car has a dead battery you may be able to jump start it by using a set of jumper cables and another car with a good battery. Be sure to follow the instructions below carefully to avoid damaging your car or injuring yourself.

What You’ll Need

Jumper cables

Another car with a good battery

Safety goggles

Gloves

Instructions

1. Park the working car next to the car with the dead battery making sure that the two cars do not touch.

2. Put on your safety goggles and gloves.

3. Open the hoods of both cars and locate the batteries.

4. Attach one end of the positive (red) jumper cable to the positive terminal of the dead battery.

5. Attach the other end of the positive (red) jumper cable to the positive terminal of the working battery.

6. Attach one end of the negative (black) jumper cable to the negative terminal of the working battery.

7. Have a helper hold the other end of the negative (black) jumper cable away from the dead battery.

8. Starting with the car with the working battery start the engine.

9. Once the engine of the working car is running start the engine of the car with the dead battery.

10. Once the engine of the car with the dead battery is running remove the jumper cables in the reverse order that you attached them.

Be sure to drive the car with the dead battery for at least 30 minutes to give the battery a chance to charge. If the battery dies again after jump starting it you may need to replace it.

What is the process to jump start a car without another car?

You will need a jumper cable and you will need to connect the red clamp to the red terminal on the dead battery and the black clamp to the black terminal.

Where do you attach the jumper cables on a car?

You will need to attach the red clamp to the red terminal on the dead battery and the black clamp to the black terminal.

In what order do you attach the jumper cables?

You will need to attach the red clamp to the red terminal on the dead battery and the black clamp to the black terminal.

What do you do once the jumper cables are attached?

Once the jumper cables are attached you will need to start the working car and let it run for a few minutes.

Then you can try to start the car with the dead battery.

Why do you let the working car run for a few minutes before trying to start the car with the dead battery?

This is done in order to charge the dead battery a little bit before trying to start the car.

What happens if the car with the dead battery still won’t start?

If the car with the dead battery still won’t start then the battery may be too damaged and will need to be replaced.

Can you jump start a car with a flat tire?

No you cannot jump start a car with a flat tire.

Can you jump start a car with an empty gas tank?

No you cannot jump start a car with an empty gas tank.

Can you jump start a car if you are not sure whether or not the battery is dead?

No you should not jump start a car if you are not sure whether or not the battery is dead.

This could cause further damage to the car.

Do you need to turn off the car before attaching the jumper cables?

Yes you will need to turn off the car before attaching the jumper cables.

Can more than one person jump start a car at the same time?

No only one person should be jump starting the car at a time.

Is it safe to jump start a car?

Yes it is safe to jump start a car as long as you follow the proper instructions and take safety precautions.

What are some safety precautions you should take when jump starting a car?

You should make sure that the jumper cables are properly attached and that you are not standing in a puddle of water when jump starting the car.

What should you do if you accidentally touch the metal clamps together?

If you accidentally touch the metal clamps together you should quickly disconnect them and try again.

What should you do after you jump start the car?

After you jump start the car you should drive it around for awhile to charge the battery.

Leave a Comment