If your car has an automatic transmission there are a few things you need to do before you can start the engine. First make sure that the parking brake is engaged. Then put the car in neutral by moving the gear selector to the middle position. Once the car is in neutral locate the start/stop button on the dash and press it. The engine should start up.
If your car has a manual transmission the process is a bit different. First make sure that the parking brake is engaged. Then locate the clutch pedal on the floor and depress it. While the pedal is depressed turn the key to the “on” position. The car should start to crank. When it does release the clutch pedal and press the accelerator. The car should start and you can then let off the accelerator.
How do you start a car with automatic transmission?
Answer 1: You start a car with automatic transmission by putting the key in the ignition and turning it to the on position.
What do you need to do before you start a car with automatic transmission?
Answer 2: You need to make sure that the car is in park before you start it.
How do you know if a car is in park?
Answer 3: There is usually a indicator on the dash that will tell you whether the car is in park or not.
Why is it important to make sure the car is in park before starting it?
Answer 4: If the car is not in park it can roll away and cause an accident.
How do you put a car in park?
Answer 5: To put a car in park you usually just push a button or lever.
Where is the button or lever to put the car in park?
Answer 6: The button or lever to put the car in park is usually located on the dash or center console.
How do you start a car with automatic transmission if the battery is dead?
Answer 7: If the battery is dead you can usually jump start the car.
How do you jump start a car with automatic transmission?
Answer 8: To jump start a car with automatic transmission you need to connect the positive and negative cables from the jump starter to the corresponding terminals on the car.
Where are the terminals to connect the cables on a car with automatic transmission?
Answer 9: The terminals to connect the cables on a car with automatic transmission are usually located under the hood.
How do you know if the cables are properly connected?
Answer 10: The cables are properly connected when the clamps are tight and secure on the terminals.
What do you need to do after the cables are connected?
Answer 11: After the cables are connected you need to start the car with the working battery and let it run for a few minutes.
Why do you need to let the car with the working battery run for a few minutes?
Answer 12: You need to let the car with the working battery run for a few minutes so that the battery can charge.
What do you do after the car with the working battery has charged?
Answer 13: After the car with the working battery has charged you can disconnect the cables and start the car with the dead battery.
What should you do if the car with the dead battery still won’t start?
Answer 14: If the car with the dead battery still won’t start you may need to replace the battery.
How do you know if you need to replace the battery?
Answer 15: You may need to replace the battery if it is more than three years old or if it has been damaged.
