When jump starting a car the red positive cable should always be attached to the positive terminal of the dead battery. The black negative cable should be attached to the negative terminal of the good battery. Once the cables are properly attached the good battery will provide power to the dead battery and the car will start.
What is the order of the cables when jump starting a car?
The order is red positive black negative then red positive to the working vehicle.
Where do you attach the cables when jump starting a car?
Attach the red positive cable to the positive terminal of the battery then the black negative cable to the negative terminal of the battery.
Finally attach the other red positive cable to the positive terminal of the working vehicle.
What should you do before attaching the cables when jump starting a car?
Make sure the vehicles are not touching each other and turn off all lights and accessories in both vehicles.
Where should the working vehicle be positioned when jump starting a car?
The working vehicle should be positioned close enough to the disabled vehicle that the cables will reach but the vehicles should not be touching.
Which type of battery is best for jump starting a car?
A battery with a high cold cranking amps (CCA) rating is best for jump starting a car.
How long should you let the working vehicle run before trying to start the disabled vehicle?
You should let the working vehicle run for about five minutes before trying to start the disabled vehicle.
How long can you leave the cables attached when jump starting a car?
You should only leave the cables attached for about 30 seconds to a minute.
What should you do if the disabled vehicle doesn’t start after a minute?
If the disabled vehicle doesn’t start after a minute check the cables to make sure they are firmly connected and try again.
If the vehicle still doesn’t start it may need a new battery.
Can you jump start a car with a weak battery?
Yes you can jump start a car with a weak battery.
However it is best to replace the battery if it is weak.
Can you jump start a car with a dead battery?
No you cannot jump start a car with a dead battery.
What should you do after jump starting a car?
After jump starting a car drive the car for a while to allow the engine to recharge the battery.
Can you use jumper cables on any type of car battery?
No you cannot use jumper cables on any type of car battery.
You can only use them on a lead-acid battery.
Can you use jumper cables on a motorcycle battery?
No you cannot use jumper cables on a motorcycle battery.
What should you do if the clamps touch each other while you are jump starting a car?
If the clamps touch each other while you are jump starting a car it will create a spark.
To avoid this make sure the clamps do not touch each other until they are both attached to a battery terminal.
What is the order of the cables when jump starting a car?
The order is red positive black negative then red positive to the working vehicle.